SMA-Male Crimp Connector for RG-174 cable
The Wilson 971139 Crimp Connector is designed for making RG-174 cable with SMA-Male connector and it attenuates signal by 0.1 dB.
What's included in the kit?
Each kit comes with everything you need for a complete installation.
SMA-Male Crimp Connector
Installation Instructions: Videos
Install The Signal Booster In a Car
Install The Signal Booster In a Truck
Install The Signal Booster In a RV
Install The Signal Booster In a SUV or Minivan
INSTALLATION GUIDES
1: Stripping the Cable
Using wire cutters, cut off the end of the cable. Using wire strippers, remove about 1/2 inch of the cable’s cover to expose the bare copper center. Using your fingers, expose about 1/8 inch of braid and foil by pulling off a small piece of the outer jacket.
2: Preparing the Wire
Slip the crimp ring over the end of the cable. Use your fingers to bend all of the braid back along the outside of the cable as evenly as possible.
3: Attaching the Connector
Push the stripped cable end into the connector so that the connector tube goes between the foil and outer housing of the cable. Push the end until the insulator is flush with the bottom of the connector. Slide the crimp ring over the bottom of the connector.
4: Crimping the Connector
Crimp the connector ring tightly around the end of the connector using a crimping tool.
5: Completing the Task
Trim the loose wires and cut the copper core wire flush with the connector end. Check connector attachment firmness by pulling on the connector and cable. Repeat the process for other cable ends needing connectors.
If you have questions or require assistance, please call our customer and tech support at 1-800-568-2723 or email at sales@WilsonAmpifiers.com. We will be happy to assist you in every step of the way.